The importance of trial operation of hydraulic breaker

      As we all know "a handy tool makes a handy man", in our daily life there are many safety accidents caused by mechanical equipment, the vast majority of this reason is inadequate maintenance of mechanical equipment. Strengthening the maintenance of mechanical equipment is indeed necessary to ensure the normal and safe operation of equipment, which can not only extend the service life of mechanical equipment, but also ensure the safe, reliable and more efficient operation of mechanical equipment, to avoid the occurrence of safety accidents and personal injury and property loss.

      The test operation is the inspection of the mechanical performance and parts installation before the hydraulic breaker is put into use. Proper debugging is also for further detecting the quality of the breaker and reducing the failure as much as possible. Usually, we need to carry out a full extension and full shrinkage test run for 3-5 times before working. The purpose of this is to exhaust the air in the system, to preheat each system, and to avoid the existence of air or water in the system effectively, gas explosion in the cylinder block.
      After the completion of the test, each part needs to be reinforced again.
      After checked the condition of each part, also should be care for the screw and wiring, if the screw is loose, it also needs to be timely reinforceed per the installation instructions and technical indicators. The no-load test machine is recommended to maintain a running time of more than 2 hours. During this period, should be check the bearing temperature closely. The temperature shall not exceed 30 degrees and all high speed rotating parts without abrasions, chips and grinding phenomenon, no abnormal noise.

      Above is the importance of trial operation of hydraulic breaker summarized by AXB, sincerely hope it will be useful.